Installation guide

Mounting the Antenna
RoamAbout Antenna Site Preparation and Installation Guide 3-9
Tomounttheomni‐directionalbasestationantennatoamast,performthefollowingsteps:
1. Withthemountsituatedsothatthearrowsstampedonitstoothedsurfacefaceup,insertthe
topoftheantennathroughthecenterholeinthemount.
2. Slidethemountdowntheantennauntilitis
seatedsecurelyaroundthebaseoftheantenna.
3. Tightenthesetscrewsonthesidesofthemountuntiltight.
4. PlacetheU‐boltaroundthemast.
5. InserttheU‐boltendsthroughthescrewholesonthesideflangeofthemount.
6. Inserttheflatandspringlockwashersoverthe
U‐boltthreadedends.
7. ThreadahexnutoneachendoftheU‐boltuntileachnutisfingertight.
8. PositionantennaatdesiredlocationalongmastandtightenbothhexnutsusinganAllen
wrench.
9. Aftermountingtheantenna,connecttheantennacablesasdescribedin“Connectingthe
AntennaCables
”onpage 3‐34.
Note: The mount’s center hole is tapered to match the taper of the antenna base. The antenna will
thus fit snugly into the mount’s center hole.