Installation guide

Overview of Connecting Cables to the Access Point
RoamAbout Antenna Site Preparation and Installation Guide 2-5
TosetuptheRoamAboutAP,performthefollowingsteps:
1. Removetheplasticcapfromtheradioconnector(s)andconnectittothepigtailcable.
2. ConnecttheAPpigtailtotheantennaasappropriateforyourcableconfiguration.Referto
ConnectingtheAntennaCablesonpage 3‐34.
3. ConnecttheEthernetcablefrom
theAPtotheAPconnectoronthepoweradapter.
4. RecordtheAP’sMACaddress(locatedonthesideoftheunit).
5. Recordtheradiocards’MACaddresses.
6. IfyouareusingPoE,connecttheEthernetcabletoyourPoEswitch.
7. IfyourswitchdoesnotsupportPoE,youwillneedto
provideaninlinepowerinjector,oruse
thelocalpoweroptionontheRBT‐4102.
Table 2-4 RBT-1602 Installation Components
# Component
8 RBT-1602 Access Point
9 RBT-1602 Access Point mounting bracket (dual/redundant 10/100 port)
10 Connection to switch (dual/redundant 10/100 port)