Installation guide

Surface Wallmount Installation

3-14

8. If you install the optional range extender antenna or

outdoor antenna (RoamAbout 802.11b PC Card only):

a) Remove the dust cover from the PC Card.

b) Insert the antenna cable connector into the PC

Card connector.

c) Gently press down on the cable connector to

secure the antenna connection.

9. Install the remote power injector or the rack mount kit, if used. Refer to Remote Power

Injector Installation on page 2-3 or the Rack Mount Kit Installation on page 2-5.

Connect the output of the remote power module to the PWR jack on the remote power

injector.

NOTE: If using two PC Cards of the same

type, one PC Card should have a range

extender antenna to prevent radio

interference. The antenna should be

placed at least 2 feet away from the R2.

The antenna is not needed if using an

802.11a PC Card with an 802.11b PC

Card.

R2_25

PWR

Network

Mounting

Hole (2)

R2_04

RoamAbout