Installation guide

Rack Mount Kit Installation
2-6
To install the rack mount kit, perform the following steps.
1. Use a cable tester to check the cable wiring to each RoamAbout R2.
Check continuity and pairing.
2. Select a mounting location:
— Close to the Ethernet wiring panel.
— Within six feet of an AC power outlet (if remote power is used).
3. Install up to three remote power injectors within the rack mount panel.
Use the screws provided in the rack mount kit to secure each remote power injector to
the rack mount panel.
4. Secure the rack mount panel to the rack using the screws provided in the kit.
5. Insert an Ethernet cable connector into the Network jack of one of the remote power
injectors.
6. Insert the RoamAbout R2 cable connector into the RoamAbout AP jack of the same
remote power injector.
7. Repeat Steps 5 and 6 for each RoamAbout R2.
8. Proceed to Chapter 3, Installing the RoamAbout R2.