Installation guide

Remote Power Injector Installation
2-4
To install the remote power injector, perform the following steps:
1. Use a cable tester to check the cable wiring to the RoamAbout R2.
Check continuity and pairing.
2. Select a mounting location:
— Close to the Ethernet wiring panel or Ethernet port.
— Within six feet of an AC power outlet (if remote power is used).
3. Secure the remote power injector.
If necessary, use the two wall anchors
provided in your installation kit.
4. Insert the Ethernet cable connector into
the Network jack.
5. Insert the RoamAbout R2 cable connector
into the RoamAbout AP jack.
6. Proceed to Chapter 3, Installing the RoamAbout R2.
PWR
Network
Mounting
Hole (2)
R2_04
RoamAbout
AP