Installation guide

1-1
Chapter 1
Preparing for Installation
This chapter describes basic considerations for successfully installing the RoamAbout R2
hardware. Before installing the RoamAbout R2, you must complete the following tasks:
• If you have an existing Access Point 2000 and want to install the RoamAbout R2 in its
place, refer to Upgrading from an Existing Access Point 2000 on page 3-2 for
important information.
• Review the site requirements.
• Select the location to install the RoamAbout R2.
• Unpack the RoamAbout R2 and check the contents of the shipment.
If installing the RoamAbout R2 in a building-to-building configuration, refer to the
RoamAbout Outdoor Antenna Site Preparation and Installation Guide for the proper
antenna cabling and grounding procedures.
After you install the RoamAbout R2, refer to the RoamAbout 802.11 Wireless Networking
Guide for configuration information.