Specifications
Configuring LSNAT
September 8, 2010 Page 13 of 28
Configuring an LSNAT Virtual Server
Procedure 3describeshowtoconfigureanLSNATvirtualserver.
3. In SLB real server configuration command
mode, if application or verification error handling
was selected, set the verification string that will
be used for this real server’s application
verification.
faildetect acv-command “command-string”
4. In SLB real server configuration command
mode, if application or verification error handling
was selected, set the verification reply string that
will be used for this real server’s application
verification.
faildetect acv-reply “reply-string”
5. In SLB real server configuration command
mode, if required, set the verification quit string
for when the protocol requires the user to issue
a command to close the session.
faildetect acv-quit “quit-string”
6. In SLB real server configuration command
mode, optionally set an exact application
verification reply string index for when the
contents of the response is not known to you.
faildetect read-till-index index-number
7. In SLB real server configuration command
mode, optionally limit the maximum number of
active connections for this real server.
maxconns maximum-number
8. In SLB real server configuration command
mode, optionally configure a weight for this real
server to be used by the round robin load
balancing algorithm.
weight weight-number
9. In SLB real server configuration command
mode, enable each real server for service.
inservice
Procedure 2 Configuring an LSNAT Real Server (continued)
Step Task Command(s)
Procedure 3 Configuring an LSNAT Virtual Server
Step Task Command(s)
1. In global router configuration command mode,
specify a name for this virtual server.
ip slb vserver vserver-name
2. In SLB virtual server configuration command
mode, optionally specify a match source port to
virtual server binding behavior.
binding match source-port {any | exact}
3. In SLB virtual server configuration command
mode, associate this virtual server with a server
farm.
serverfarm serverfarm-name