Specifications

Configuring Link Aggregation
December 02, 2010 Page 11 of 23
Table 5describeshowtomanagelinkaggregation.
5. Optionally, modify the LAG port parameters. See
Table 2 on page 7 for a description of port
parameters. See Table 4 on page 10 for LACP
port active state for your platform.
set port lacp port port-string
{
[aadminkey aadminkey] [aportpri aportpri]
[padminsyspri padminsyspri] [padminsysid
padminsysid] [padminkey padminkey]
[padminportpri padminportpri] [padminport
padminport]
[aadminstate {lacpactive | lacptimeout |
lacpagg | lacpsync | lacpcollect | lacpdist |
lacpdef | lacpexpire}]
[padminstate {lacpactive | lacptimeout |
lacpagg | lacpsync | lacpcollect | lacpdist |
lacpdef | lacpexpire}]
[enable | [disable]
}
6. Optionally, change how flows behave when a
port joins or is removed from a LAG.
set lacp flowRegeneration {enable |
disable}
7. Optionally, change the out-port behavior for
flows over the LAG.
set lacp outportAlgorithm {dip-sip |
da-sa |
round-robin}
8. Optionally, assign static ports to a LAG when the
partner device only supports a non-LACP
method of aggregation.
set lacp static lagportstring [key] port-string
Table 5 Managing Link Aggregation
Task Command
Reset LACP to the default state of
enabled.
clear lacp state
Reset LACP system priority or admin
key settings to the default values.
clear lacp {[asyspri] [aadminkey port-string]}
Remove specific static ports from an
aggregation.
clear lacp static lagportstring port-string
Reset the single port LAG feature to
the default value of disabled.
clear lacp singleportlag
Reset a link aggregation port setting to
the default value for one or more ports.
See Table 2 on page 7 for a
description of port parameters.
clear port lacp port port-string
{
[aadminkey] [aportpri] [padminsyspri] [padminsysid]
[padminkey] [padminportpri] [padminport]
[aadminstate {lacpactive | lacptimeout | lacpagg | lacpsync |
lacpcollect | lacpdist | lacpdef | lacpexpire | all}]
[padminstate {lacpactive | lacptimeout | lacpagg | lacpsync |
lacpcollect | lacpdist | lacpdef | lacpexpire | all}]
}
Procedure 1 Configuring Link Aggregation (continued)
Step Task Command(s)