Specifications

CoS Hardware Resource Configuration
May 09, 2011 Page 26 of 38
CoS Reference Layer
TheCoSreferencelayerisnotapplicabletofloodcontrol.
CoS Settings Layer
FortheCoSsettingslayer,usingthecossettingscommandtoenablefloodcontrolforCoSsettings
3(802.1priority3):
System(su)->set cos settings 3 flood-ctrl enable
Enable CoS State
CoSconfigurationmustbeenabledtobecomeactive,usingthesetcosstateenablecommand:
System(su)->set cos state enable
Flood Control Configuration Example Show Command Output
UsetheshowcossettingscommandtodisplaythefloodcontrolstatetoCoSinde x (802.1priority)
mapping:
show cos settings
* Means attribute has not been configured
CoS Index Priority ToS TxQ IRL ORL Drop Prec Flood-Ctrl
--------- ---------- ------- ----- ----- ----- --------- ----------
0 0 * 0 * * * Disabled
1 1 * 2 * * * Disabled
2 2 * 4 * * * Disabled
3 3 * 6 * * * Enabled
4 4 * 8 * * * Disabled
5 5 * 10 * * * Disabled
6 6 * 12 * * * Disabled
7 7 * 14 * * * Disabled
Usetheshowcosport‐resourceflood‐ctrlcommandtodisplaythefloodcontrolunitandrateto
floodcontrolresourcemapping:
System(su)->show cos port-resource flood-ctrl 1.0
'?' after the rate value indicates an invalid rate value
Group Index Resource Type Unit Rate Rate Limit Type Action
----------- -------- ---- ---- ---------- --------------- ------
1.0 1 fld pps 3000 none
1.0 2 fld perc none none
1.0 3 fld perc none none