Specifications

Configuring Port Mirrors
May 04, 2011 Page 10 of 15
Clearing Port Mirroring
Usethiscommandtoclearaportmirroringconfiguration:
clear port mirroring source destination
Example
Thefollowingexampleclearsportmirroringbetweensourceportge.6.23andtargetportge.6.26:
enterasys(switch-su)-> show port mirroring
Source Destination Direction AdminStatus OperStatus
------------ ------------ --------- ----------- ----------
ge.6.23 ge.6.26 Rx and Tx enabled enabled
ge.6.24 ge.6.26 Rx and Tx enabled enabled
ge.6.25 ge.6.26 Rx and Tx enabled enabled
matrix-x(switch-su)-> clear port mirroring ge.6.23 ge.6.26
matrix-x(switch-su)-> show port mirroring
Source Destination Direction AdminStatus OperStatus
------------ ------------ --------- ----------- ----------
ge.6.24 ge.6.26 Rx and Tx enabled enabled
ge.6.25 ge.6.26 Rx and Tx enabled enabled
Stackable and Standalone Switches
EnterasysA‐Series,B‐Series,C‐SeriesstackablefixedswitchesandD‐Series,G‐Series,andI‐Series
standalonefixedswitchessupportthefollowingmirroringfeatures:
• Mirroringcanbeconfiguredinamany‐to‐oneconfigurationsothatonetarget(destination)
portcanmonitortrafficonupto8sourceports.
•Onlyonemirrordestinationportcan beconfiguredperstackorstandalone.
•Bothtransmitandreceivetrafficwillbemirrored.
•Adestinationportwillonlyactasamirroringportwhenthesessionisoperationallyactive.If
themirroringsessionisnotoperationallyactive,thenthedestinationportwillactasa
normal
portandparticipateinallnormaloperationwithrespecttotransmittingtrafficand
participatinginprotocols.
Reviewing, Setting, and Clearing Port Mirroring
Commandsforconfiguringstackableandstandalonefixedswitchdevicesareverysimilartothose
describedandshownintheoutputexamplesfortheN‐Series,S‐Series,K‐Seriesonpage6.
Usethiscommandtodisplaythestatusofportmirroringandinformationaboutanymirrors
configured:
show port mirroring
Usethiscommandtocreateanewmirroringrelationship,ortoenableordisableanexisting
mirroringrelationship:
set port mirroring {create | disable | enable}
Note: One-to-many mirroring, many-to-many mirroring, and IDS, LAG, and VLAN mirroring are not
supported.