Specifications

Configuring Policy
May 18, 2009 Page 17 of 32
Procedure 2describeshowtoconfigureclassificationrulesasanadministrativeprofileorto
assignpolicyrulestoapolicyrole.
6. Optionally, for enhanced policy capable devices,
set a policy maptable entry that associates a
VLAN with a policy profile. This option is also
supported by the B3, C3, and G3 for releases
6.3 and greater.
set policy maptable {vlan-list
profile-index}
7. Optionally, set a policy maptable response.
• tunnel - Applies the VLAN tunnel attribute.
• policy - Applies the policy specified in the
filter-ID.
• both - An enhanced policy option that applies
either or all the filter-ID and VLAN tunnel
attributes or the policy depending upon
whether one or both are present. This option
is also supported by the B3, C3, and G3 for
releases 6.3 and greater.
set policy maptable response
{tunnel | policy | both}
Procedure 2 Configuring Classification Rules
Step Task Command(s)
1. In switch command mode, optionally set an
administrative profile to assign traffic
classifications to a policy role.
See Table 1 on page 8 for traffic
classification-type descriptions and enhanced
policy information.
See the set policy rule command discussion in
the command reference guide that comes with
your device for traffic classification data and
mask information.
• port-string - (Optional) Applies this
administratively-assigned rule to a specific
ingress port. N-Series devices with firmware
versions 3.00.xx and higher also support the
set policy port command as an alternative to
administratively assign a profile rule to a port.
• storage-type - (Optional) An enhanced
policy that adds or removes this entry from
non-volatile storage.
• admin-pid - Associates this administrative
profile with a policy profile index ID. Valid
values are 1 - 1023.
• syslog - (Optional) An enhanced policy that
enables or disables sending of syslog
messages on first rule use.
set policy rule admin-profile
classification-type [data] [mask
mask] [port-string port-string]
[storage-type {non-volatile |
volatile}] [admin-pid admin-pid]
[syslog {enable | disable}][trap
{enable | disable}] [disable-port
{enable | disable}]
Procedure 1 Configuring Policy Roles (continued)
Step Task Command(s)