Specifications

Configuring PoE
June 3, 2011 Page 4 of 14
Configuring PoE
Table 2liststhePoEsettingsthatyoucanconfigurethroughthe CLIoneachPoE‐compliant
Enterasysdevice.
Refertotheappropriatedevice‐specificPoEconfigurationprocedure.
•StackablefixedswitchesA2,A4,B2,B3,C2,andC3:Procedure 1onpage5
• StandaloneD‐Series:Procedure 1onpage5
•StackablefixedswitchesB5
andC5:Procedure 2onpage6
• StandaloneG‐Series:Procedure 3onpage7
•ModularN‐Series,S‐Series,andK‐Series:Procedure 4onpage10
Table 2 PoE Settings Supported on Enterasys Devices
Setting
A2 A4 B2
B3
B5
C2 C3
C5
D-Series G-Series N-Series S-Series K-Series
Port-specific PoE parameters XXXXXXXXXXXXX
SNMP traps XXXXXXXXXXXXX
PoE usage threshold XXXXXXXXXXXXX
PD detection method XXXXXXXXXX
System power redundancy X X
System power allocation XXXX
Module power allocation XXXX
PD power management X X X X X X
Note: You must be logged on to the Enterasys device with read-write access rights to use the
commands shown in the procedures in the following sections.