Specifications

Configuring LLDP
October 15, 2008 Page 9 of 14
Refertothedevice’sCLIReferenceGuideorConfigurationGuide,asapplicable,formoreinformation
abouteachcommand.
Return LLDP parameters to their default values. clear lldp {all | tx-interval | hold-
multipler | trap-interval | med-fast-
repeat}
Return the port status to the default value of both
(both transmitting and processing received
LLDPDUs are enabled).
clear lldp port status port-string
Return the port LLDP trap setting to the default value
of disabled.
clear lldp port trap port-string
Return the port LLDP-MED trap setting to the default
value of disabled.
clear lldp port med-trap port-string
Return the port ECS ELIN location setting to the
default value of null.
This command applies to Enterasys Matrix N-Series
devices only.
clear lldp port location-info elin
port-string
Return network policy for a set of applications on a
port or range of ports to default values.
This command applies to Enterasys Matrix N-Series
devices only.
clear lldp port network-policy {all |
voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice
| video-conferencing | streaming-video
| video-signaling} {[state ]
[ tag ] [vid ] [cos ] [dscp ] } port-
string
Clear the optional LLDP and LLDP-MED TLVs to be
transmitted in LLDPDUs by the specified port or
ports to the default value of disabled.
clear lldp port tx-tlv {[all] | [port-
desc] [sys-name] [sys-desc] [sys-cap]
[mgmtaddr] [vlan-id] [stp] [lacp]
[gvrp
] [mac-phy] [poe] [link-aggr]
[max-frame] [medcap] [med-pol] [med-
loc] [med-poe]} port-string
Table 1 LLDP Configuration Commands (continued)
Task Command