Specifications

Configuring LLDP
October 15, 2008 Page 8 of 14
Set the time-to-live value used in LLDP frames sent
by this device. The time-to-live for LLDPDU data is
calculated by multiplying the transmit interval by the
hold multiplier. The default value is 4.
set lldp hold-multiplier multiplier-val
Set the minimum interval between LLDP
notifications sent by this device. LLDP notifications
are sent when a remote system change has been
detected. The default value is 5 seconds.
set lldp trap-interval frequency
Set the number of fast start LLDPDUs to be sent
when an LLDP-MED endpoint device is detected.
Network connectivity devices transmit only LLDP
TLVs in LLDPDUs until they detect that an LLDP-
MED endpoint device has connected to a port. At
that point, the network connectivity device starts
sending LLDP-MED TLVs at a fast start rate on that
port. The default value is 3.
set lldp med-fast-repeat count
Enable or disable transmitting and processing
received LLDPDUs on a port or range of ports.
set lldp port status {tx-enable | rx-
enable | both | disable} port-string
Enable or disable sending LLDP traps when a
remote system change is detected.
set lldp port trap {enable | disable}
port-string
Enable or disable sending an LLDP-MED trap when
a change in the topology has been sensed on the
port (that is, a remote endpoint device has been
attached or removed from the port).
set lldp port med-trap {enable |
disable} port-string
Configure LLDP-MED location information on a port
or range of ports. Currently, only Emergency Call
Services (ECS) Emergency Location Identification
Number (ELIN) is supported. ELIN is a special
phone number used to indicate location, and is
assigned and associated with small geographies in
the organization.It is one of the forms of identification
that the location identification TLV provides.
This command applies to Enterasys Matrix N-Series
devices only.
set lldp port location-info elin elin-
string port-string
Select the optional LLDP and LLDP-MED TLVs to be
transmitted in LLDPDUs by the specified port or
ports.
set lldp port tx-tlv {[all] | [port-
desc] [sys-name] [sys-desc] [sys-cap]
[mgmtaddr] [vlan-id] [stp] [lacp]
[gvrp] [
mac-phy] [poe] [link-aggr]
[max-frame] [medcap] [med-pol] [med-
loc] [med-poe]} port-string
Configure network policy for a set of applications on
a port or range of ports. The policies configured with
this command are sent in LLDPDUs as LLDP-MED
Network Policy TLVs. Multiple Network Policy TLVs
can be sent in a single LLDPDU.
This command applies to Enterasys Matrix N-Series
devices only.
set lldp port network-policy {all |
voice | voice-signaling | guest-voice |
guest-voice-signaling | softphone-voice
| video-conferencing | streaming-video
| video-signaling} [state {enable |
disable}] [ tag {tagged | untagged}]
[vid {vlan-id | dot1p}] [cos cos-value]
[dscp dscp-value] port-string
Table 1 LLDP Configuration Commands (continued)
Task Command