Specifications
Configuring Multicast
April 16, 2009 Page 26 of 32
Procedure 7describesthebasicstepstoconfigurePIM‐SMonaSecureStackC2andC3devices
andG‐Seriesdevices.
)))))
4. If static RP set distribution is desired, configure
the static RP set information in global
configuration mode. The RP set information
must be the same on all PIM routers in the
network.
Note: Static RP set distribution cannot be
combined with BSR RP set distribution in the
same PIM domain. Routers with statically
configured RP set information discard RP set
information learned from a BSR.
ip pim rp-address rp-address group-
address group-mask [priority
priority]
5. In interface configuration mode, configure PIM-
SM on the Matrix N-Series router interfaces that
will run PIM-SM.
ip pim sparse-mode
Procedure 7 Basic PIM-SM Configuration (SecureStack C2 and C3 and G-Series)
Step Task Command(s)
1. In global configuration mode, enable PIM-SM on
the device.
ip pimsm
2. In global configuration mode, if desired, create a
manual RP IP address for the PIM-SM router.
ip pimsm staticrp ipaddress
groupadress groupmask
3. In interface configuration mode, enable PIM-SM
on the device’s VLAN interfaces that will run
PIM-SM.
ip pimsm enable
Procedure 6 Basic PIM-SM Configuration (continued)(Enterasys Matrix N-Series)
Step Task Command(s)