Specifications

Configuring Multicast
April 16, 2009 Page 23 of 32
Router R2 Configuration
FortheVLAN1interface,whichprovidesconnectiontotheRouterR1,anIPaddressisassigned
andDVMRPisenabled.FortheVLAN3interfacewhichprovidesconnectiontothehostnetwork,
anIPaddressisassignedandDVMRPisenabled.
matrix->router
matrix->router#enable
matrix->router(config)#interface vlan 1
matrix->router(config-if(Vlan 1))#ip address 192.0.1.1 255.255.255.0
matrix->router(config-if(Vlan 1))#ip dvmrp
matrix->router(config-if(Vlan 1))#no shutdown
matrix->router(config-if(Vlan 1))#exit
matrix->router(config)#interface vlan 3
matrix->router(config-if(Vlan 3))#ip address 192.20.0.1 255.255.255.0
matrix->router(config-if(Vlan 3))#ip dvmrp
matrix->router(config-if(Vlan 3))#no shutdown
matrix->router(config-if(Vlan 3))# exit
Displaying DVMRP Information
Table 11liststheDVMRPshowcommandsforEnterasysMatrixN‐Seriesdevices.
Table 12liststheDVMRPshowcommandsforSecureStackC2 andC3devicesandG‐Series
devices.
Refertothedevice’sCLIReferenceGuideorConfigurationGuide ,asapplicable,foranexampleof
eachcommand’soutput.
Table 11 DVMRP Show Commands (Enterasys Matrix N-Series)
Task Command
Display information about the routes in the DVMRP
routing table.
show ip dvmrp route
Display the IP multicast routing table. show ip mroute [unicast-source-address
| multicast-group-address] [summary]
Table 12 DVMRP Show Commands (SecureStack C2 and C3 and G-Series)
Task Command
Display DVMRP routing information, neighbor
information, or DVMRP enable status.
show ip dvmrp [route|neighbor|status]
Display the IP multicast routing table. show ip mroute [unicast-source-address
| multicast-group-address] [summary]