Specifications

Configuring Multicast
April 16, 2009 Page 21 of 32
Table 10liststheDVMRPconfigurationcommandsfor SecureStackC2andC3devicesandG‐
Seriesdevices.
Basic DVMRP Configurations
Bydefault,DVMRPisdisabledgloballyonEnterasysMatrixN‐Series,SecureStackC2andC3,and
G‐Seriesdevicesandattachedinterfaces.BasicDVMRPconfigurationincludesthefollowing
steps:
1. CreatingandenablingVLANs.
2. EnablingIGMPonthedevice(onlyforSecureStackC2andC3devicesandG‐Seriesdevices)
andonthe
VLANs.
3. EnablingDVMRPontheVLANs.
BothProcedure 4andProcedure 5assumethefollowing:
•VLANshavebeenconfiguredandenabledwithIPinterfaces.
•IGMPhasbeenenabled.ForinformationonenablingIGMP,seeConfiguringIGMPonpage
15.
Enterasys Matrix N-Series
Procedure 4describesthebasicstepstoconfigureDVMRPonEnterasysMatrixN‐Seriesdevices.
Table 10 DVMRP Configuration Commands (SecureStack C2 and C3 and G-Series)
Task Command
Enable the DVMRP process. Use the no command
to disable the DVMRP process.
ip dvmrp
no ip dvmrp
Enable DVMRP on an interface. Use the no
command to disable DVMRP on an interface.
ip dvmrp enable
no ip dvmrp enable
Configure the metric associated with a set of
destinations for DVMRP reports.
ip dvmrp metric metric
Procedure 4 Basic DVMRP Configuration (Enterasys Matrix N-Series)
Step Task Command
1. In router interface configuration mode, enable
DVMRP on each VLAN interface on which DVMRP
will run.
ip dvmrp