Specifications

Setting Basic Device Properties show physical assetid
2-56 Startup and General Configuration
show physical assetid
UsethiscommandtodisplaytheassetIDforamodule.
Syntax
show physical assetid module module
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplayassetIDinformationformodule1.Inthiscase,nonehasbeen
configured:
Matrix(rw)->show physical assetid module 1
module-1 assetID=<empty string> entity=71
set physical assetid
UsethiscommandtosettheassetIDforamodule.
Syntax
set physical assetid module module string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
modulemodule SpecifiesthemoduleforwhichtodisplayanassetID.
modulemodule SetsanassetIDforaspecificmodule.
string SpecifiestheassetID.
Important Notice
Module, slot, and certain other hardware-based parameters in the Matrix N Series Standalone (NSA) CLI
support only chassis based N Series devices, such as the N7, N5, N3 or N1. Executing commands in the
NSA CLI with modular parameters not supported by the standalone will result in an error message.