Specifications

clear physical alias Setting Basic Device Properties
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 2-55
Defaults
Ifstringisnotspecified,thealiasofthetypespecified willbecleared.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtosetthealiasforthechassisto“chassisone”:
Matrix(rw)->set physical alias chassis chassisone
clear physical alias
Usethiscommandtoresetthealiasforaphysicalobjecttoazero‐lengthstring.
Syntax
clear physical alias {[chassis] [slot slot] [backplane backplane] [module module]
[powersupply powersupply] [powersupply-slot powersupply-slot] [fan] [fan-slot]
[port-string port-string]}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtosetclearthealiassetforthechassis:
Matrix(rw)->clear physical alias chassis
Important Notice
Module, slot, and certain other hardware-based parameters in the Matrix N Series Standalone (NSA) CLI
support only chassis based N Series devices, such as the N7, N5, N3 or N1. Executing commands in the
NSA CLI with modular parameters not supported by the standalone will result in an error message.
chassis Clearsthechassisalias.
slotslot Clearsandaliasforaspecificslot.
backplanebackplane Clearsandaliasforaspecificbackplane.Validvaluesare1forFTM1
and2forFTM2.
modulemodule Clearsanaliasforaspecificmodule.
powersupply
powersupply
Clearsanaliasforaspecificpowersupply.
Validvaluesare1or2.
fan Clearsthefantrayalias
port‐stringport‐string Clearsanaliasforaspecificport.