Specifications

set radius-snooping timeout Understanding RADIUS Snooper
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 26-3
Parameters
Defaults
None.
Mode
Read‐Write.
Usage
ThiscommanddoesnotenableRSontheportsforthisdevice.ToenableportsforRSseethe
commandsetradius‐snoopingport onpage 26‐4.
Example
ThisexampleshowshowtoenableRSonthisdevice:
Matrix(rw)->set radius-snooping enable
set radius-snooping timeout
UsethiscommandtosetthenumberofsecondsthatthefirmwarewaitsforaRADIUSresponse
frametobereturnedfromtheRADIUSserver,aftersuccessfullysnoopingaRADIUSrequest
framefromtheclient.
Syntax
set radius-snooping timeout seconds
Parameters
Defaults
None.
Mode
Read‐Write.
Usage
Ifnoresponseisseenbeforethetimeoutexpires,thesessionisterminated.
Radius‐Snoopertimeoutvaluesareroundedtothenearestfactorof10.Forexample,aconfigured
valueof22wouldbeanactualvalueof20.
enable GloballyenablesRSonthisdevice.
disable GloballydisablesRSonthisdevice.
seconds Specifiesthenumberofsecondsthatthefirmwarewaitsfromthetimeit
successfullysnoopsaRADIUSrequestframe,foraRADIUSresponse
frametobereturnedfromtheRADIUSserver.Default:20