Specifications

set tacacs command Configuring TACACS+
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 25-71
set tacacs command
UsethiscommandtoenableordisableTACACS+accountingorauthorizationonaper‐command
basis.
Syntax
set tacacs command {accounting | authorization} {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Inorderforper‐commandaccountingorauthorizationbyaTACACS+servertotakeplace,the
commandmustbeexecutedwithinanauthorizedsession.
Whenper‐commandaccountingisenabled,theTACACS+serverwilllogaccountinginformation,
suchasstartandstoptimes,IPaddressoftheclient,andsoforth,
foreachcommandexecuted
duringthesession.
Whenper‐commandauthorizationisenabled,theTACACS+serverwillcheckwhethereach
commandispermittedforthatauthorizedsessionandreturnasuccessorfail.Iftheauthorization
fails,thecommandisnotexecuted.
Example
ThisexampleshowshowtoenableTACACS+authorizationonacommand basis.
Matrix(rw)->set tacacs command authorization enable
show tacacs singleconnect
UsethiscommandtodisplaythecurrentstatusoftheTACACS+client’sabilitytosendmultiple
requestsoverasingleTCPconnection.
Syntax
show tacacs singleconnect [state]
Parameters
accounting|
authorization
SpecifieseitherTACACS+accountingorauthorizationtobeenabledor
disabled.
enable|disable Enableordisableaccountingorauthorizationonaper‐commandbasis.
state (Optional)Specifiesthatonlythesingleconnectionstateshouldbe
displayed.