Specifications

show radius Configuring RADIUS
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 25-53
Configuring RADIUS
Purpose
Toperformthefollowing:
•ReviewtheRADIUSclient/serverconfigurationonthedevice.
•EnableordisabletheRADIUSclient.
•Setlocalandremoteloginoptions.
•Setprimaryandsecondaryserverparameters,includingIPaddress,timeoutperiod,
authenticationrealm,andnumberofuserloginattemptsallowed.
•ResetRADIUSserversettingstodefaultvalues.
• ConfigureaRADIUS
accountingserver.
Commands
show radius
UsethiscommandtodisplaythecurrentRADIUSclient/serverconfiguration.
Syntax
show radius [state | retries authtype || timeout | server [index | all]]
Parameters
For information about... Refer to page...
show radius 25-53
set radius 25-54
clear radius 25-55
show radius accounting 25-56
set radius accounting 25-57
clear radius accounting 25-58
state (Optional)DisplaystheRADIUSclient’senablestatus.
retries (Optional)DisplaysthenumberofretryattemptsbeforetheRADIUS
servertimesout.
authtype (Optional)DisplaystheRADIUSserver’sauthenticationtype.
server(Optional)DisplaysRADIUSserverconfigurationinformation.
timeout (Optional)Displaysthemaximumamountoftime(inseconds)to
establishcontactwiththeRADIUSserverbefore
retryattemptsbegin.
index|all (Optional)Displaysconfigurationinformationforaspecifiedserveror
allRADIUSservers.