Specifications

set cep detection-id type Configuring Convergence End Points (CEP) Phone Detection
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 25-45
Usage
ThiscommandappliesonlytoSiemens,H.323,andSIPphonedetection.Ciscodetectionuses
CiscoDPasitsdiscoverymethod.
Example
ThisexampleshowshowtocreateCEP detectiongroup1:
Matrix>set cep detection-id 1 create
set cep detection-id type
UsethiscommandtospecifywhetheraphonedetectiongroupwilluseH.323,SiemensorSIPas
itsphonediscoverytype.
Syntax
set cep detection-id id type {h323 | siemens | sip}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
ThiscommandappliesonlytoSiemens,H.323,andSIPphonedetection.Ciscodetectionuses
CiscoDPasitsdiscoverymethod.
Therearecurrently3manualdetectiontypes(Siemens,H323,SIP).Undermanualdetection
configuration,foreachofthetypes,the“EndpointPhoneType”willbe listedcorrectly.However,
thehighandlow
portswillnotreflectdefaultportsforthe“EndpointPhoneTypes”.Theuserwill
havetoconfiguretheportlowand highoptionstomatchtheirneedsfortheEndpointPhoneType
beingconfigured,asdescribedin“setcepdetection‐idporthigh|portlow”onpage 25‐47.
Example
ThisexampleshowshowtosetthephonedetectiontypetoH.323forCEPgroup1:
Matrix>set cep detection-id 1 type h323
id Specif iesaCEPconfigurationgroupID.Thisgroupmustbecreated
andenabledusingthesetcepdetection‐idcommandasdescribedin
“setcepdetection‐id”onpage 25‐44.Validvaluesare1‐2147483647.
h323|siemens|sip SpecifiesthephonetypetodetectasH.323,Siemensor
SIP.