Specifications

set flowlimit notification Configuring Flow Setup Throttling (FST)
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 24-33
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Whenenabled,thisallowsportsconfiguredwitha“trap”actiontosendanSNMPtrapmessage
whenaspecifiedflowlimitisreached.
Whenenabled,thisallowsportsconfiguredwitha“disable”actiontoshutdown.Forinformation
onusingthesetflowlimitlimitcommandtoconfiguresetadisableaction
onaport,referto“set
flowlimitlimit”onpage 24‐27.
Example
Thisexampleshowshowtoenabletheflowlimitshutdownfunction:
Matrix(rw)->set flowlimit shutdown enable
set flowlimit notification
Usethiscommandtoenableordisableflowlimitnotification,ortosetanotificationinterval.
Syntax
set flowlimit notification {disable | enable | interval}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoenabletheflowlimitnotificationfunction:
Matrix(rw)->set flowlimit notification enable
enable|disable Enablesordisablestheflowlimitshutdownfunction.
disable|enable DisablesorenablesSNMPnotification.
interval Specifiesanotificationinterval(inseconds)forSNMPtrapmessages.
Validvaluesare0‐4294967295.