Specifications

Configuring RIP redistribute
21-18 Routing Protocol Configuration
Parameters
Defaults
•Ifmetricvalueisnotspecified,1willbeapplied.
•Ifsubnetsisnotspecified,onlynon‐subnettedrouteswillberedistributed.
Mode
Routerconfiguration:Matrix>Router(config‐router)#
Usage
The“no”formofthiscommandclearsredistributionparameters.
Example
ThisexampleshowshowtoredistributeroutinginformationdiscoveredthroughOSPFprocessID
1non‐subnettedroutesintoRIPupdatemessages:
Matrix>Router(config)#router rip
Matrix>Router(config-router)#redistribute ospf 1
connected Specifiesthatnon‐RIProutinginformationdiscoveredviadirectly
connectedinterfaceswillberedistributed.
ospf SpecifiesthatOSPFroutinginformationwillberedistributedinRIP.
process‐id Specifies theprocessID,aninternallyusedidentificationnumberfor
eachinstanceoftheOSPFroutingprocessrunonarouter.Validvalues
are
1to65535.
static Specifiesthatnon‐RIProutinginformationdiscoveredviastaticroutes
willberedistributed.Staticroutesarethosecreatedusingtheiproute
commanddeta iledin“iproute”onpage 16‐26.
metricmetricvalue (Optional)Specifiesametricfortheconnected,OSPForstatic
redistributionroute.Thisvalue
shouldbeconsistentwiththe
designationprotocol.
subnets (Optional)Specifiesthatconnected,OSPForstaticroutesthatare
subnettedwillberedistributed.