Specifications

network Configuring RIP
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 21-3
Parameters
None.
Defaults
None.
Mode
Routercommand,Globalconfiguration:Matrix>Router(config)#
Usage
YoumustexecutetherouterripcommandtoenabletheprotocolbeforecompletingmanyRIP‐
specificconfigurationtasks.Fordetailsonenablingconfigurationmodes,refertoTable 2‐8in
“EnablingRouterConfigurationModes”onpage 2‐91.
The“no”formofthiscommanddisablesRIP.
Example
ThisexampleshowshowtoenableRIP:
Matrix>Router#configure terminal
Matrix>Router(config)#router rip
Matrix>Router(config-router)#
network
UsethiscommandtoattachanetworkofdirectlyconnectednetworkstoaRIProutingprocess,or
toremoveanetworkfromaRIProutingprocess.
Syntax
network ip-address
no network ip-address
Parameters
Defaults
None.
Mode
Routercommand,Routerconfiguration:Matrix>Router(config‐router)#
Usage
The“no”formofthiscommandremovesthenetworkfromtheRIProutingprocess.
ip‐address SpecifiestheIPaddressofadirectlyconnectednetworkthatRIPwill
advertisetoitsneighboringrouters.