Specifications

Configuring NetFlow set netflow export-interval
15-6 NetFlow Configuration
Parameters
Defaults
SinceonlyonecollectoraddressperEnterasysMatrixsystemissupported,enteringtheIPaddress
andUDPportinformationisnotrequired.Executingthiscommandwithoutanyparameterswill
returnthecollectoraddressto“NotConfigured.”
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtocleartheNetFlowcollectoraddress:
Matrix(rw)->clear netflow export-destination
set netflow export-interval
UsethiscommandtoconfiguretheNetFlowexportinterval.
Syntax
set netflow export-interval interval
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
EachDFEbladeintheEnterasysMatrixsys temwilltransmitaNetFlowpacketwhen:
•IthasaccumulatedthemaximumnumberofNetFlowrecordsperpacket,whichis30,or
•Ithasaccumulatedfewerthan30NetFlowrecordsandtheactiveflowtimerhasexpired,or
•Theflowexpires(agesoutoris
invalidated).
Example
ThisexampleshowshowtosettheNetFlowexportintervalto10minutes:
Matrix(rw)->set netflow export-interval 10
ip‐address (Optional)Specifies theIPaddressoftheNetFlowcollectortoclear.
udp‐port (Optional)SpecifiestheUDPportnumberusedbyNetFlowcollector.
interval Settheactiveflowtimervalue,between1to60minutes.Thedefault
valueis30minutes.