Specifications

set movedaddrtrap Managing Switch Network Addresses and Routes
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 12-15
Parameters
Defaults
Ifport‐stringisnotspecified,MACaddresstrapsforallportswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaythestatusofMACaddresstrapsonge.1.1through3:
Matrix(rw)->show movedaddrtrap ge.1.1-3
Moved Address Traps Globally enabled
Port Enable State
--------- ------------
ge.1.1 enabled
ge.1.2 enabled
ge.1.3 enabled
set movedaddrtrap
UsethiscommandtoenableordisableSNMPtrap messaging,globallyorononeormoreports,
whenmovedsourceMACaddressesaredetected.
Syntax
set movedaddrtrap [port-string] {enable | disable}
Parameters
Defaults
Ifport‐stringisnotspecified,MACaddresstrapswillbegloballyenabledordisabled.
Mode
Switchcommand,Read‐Write.
port‐string (Optional)DisplaysMACaddresstrapsforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.
port‐string (Optional)Specifiestheport(s)onwhichtoenableordisableMAC
addresstraps.Foradetaileddescriptionofpossibleport‐stringvalues,
referto“PortStringSyntaxUsedintheCLI”onpage 4‐2.
enable|disable EnablesordisablesSNMPtrapmessagingwhenmovedsourceMAC
addressesare
detected.