Specifications

Enterasys Matrix N Standalone (NSA) Series Configuration Guide 2-1
2
Startup and General Configuration
ThischapterdescribesfactorydefaultsettingsandtheStartupandGeneralConfigurationsetof
commands.
Startup and General Configuration Summary
Atstartup,theMatrixSeriesdeviceisconfiguredwithmanydefaultsandstandardfeatures.The
followingsectionsprovideinformationonhowtoreviewandchangefactorydefaults,howto
customizebasicsystemsettingstoadapttoyourworkenvironment,andhowtopreparetorun
thedeviceinroutermode.
Factory Default Settings
ThefollowingtableslistfactorydefaultdevicesettingsavailableontheMatrixSeriesdevice.
Table 2‐1listsdefaultsettingsforMatrixSeriesswitchoperation.Table 2‐2listsdefaultsettingsfor
routermodeoperation.
For information about... Refer to page...
Startup and General Configuration Summary 2-1
Setting User Accounts and Passwords 2-15
Managing the Management Authentication Notification MIB 2-26
Setting Basic Device Properties 2-30
Activating Licensed Features 2-58
Reviewing and Selecting a Boot Firmware Image 2-60
Starting and Configuring Telnet 2-64
Managing Configuration and Image Files 2-68
Enabling or Disabling the Path MTU Discovery Protocol 2-78
Pausing, Clearing and Closing the CLI 2-80
Resetting the Device 2-82
Gathering Technical Support Information 2-86
Preparing the Device for Router Mode 2-88
Reviewing and Configuring Routing 2-89