Specifications

show port egress Configuring the VLAN Egress List
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 7-17
Configuring the VLAN Egress List
Purpose
ToassignorremoveportsontheegresslistofaparticularVLAN.Thisdetermineswhichports
willbeeligibletotransmitframesforaparticularVLAN.Forexample,ports1,5,9,8couldbe
assignedtotransmitframesbelongingtoVLAN5(VLANID=5).
Theportegresstypefor
allportsdefaultstotaggingtransmittedframes,butcanbechangedto
forbiddenoruntagged.Ingeneral,VLANshavenoegress(exceptforVLAN1)untiltheyare
configuredbystaticadministration,orthroughdynamicmechanisms(i.e.,GVRP,policy
classificationorEnterasysdynamicegress).
Settingaporttoforbiddenprevents
itfromparticipatinginthespecifiedVLANandensuresthat
anydynamicrequests(eitherthroughGVRPordynamicegress)fortheporttojointheVLANwill
beignored.Settingaporttountaggedallowsittotransmitframeswithoutatagheader.This
settingisusuallyusedtoconfigurea
portconnectedtoanenduserdevice.
ThedefaultVLANdefaultsitsegresstountaggedforallports.
Commands
show port egress
UsethiscommandtodisplaytheVLANmembershipforoneormoreports.
Syntax
show port egress [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,VLANmembershipwillbedisplayedforallports.
Mode
Switchcommand,Read‐Write.
For information about... Refer to page...
show port egress 7-17
set vlan egress 7-18
clear vlan egress 7-19
show vlan dynamic egress 7-20
set vlan dynamicegress 7-20
port‐string (Optional)DisplaysVLANmembershipforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.