Specifications

show spantree txholdcount Configuring Spanning Tree Bridge Parameters
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 6-33
Example
Thisexampleshowshowtocleartopologychangetrapsuppressionsettings:
Matrix(rw)->clear spantree tctrapsuppress
show spantree txholdcount
UsethiscommandtodisplaythemaximumBPDUtransmissionrate.
Syntax
show spantree txholdcount
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythetransmitholdcountsetting:
Matrix(rw)->show spantree txholdcount
Tx hold count = 3.
set spantree txholdcount
UsethiscommandtosetthemaximumBPDUtransmissionrate.
Syntax
set spantree txholdcount txholdcount
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
MaximumBPDUtransmissionrateisthenumberofBPDUswhichwillbetransmittedbefore
transmissionsaresubjecttoaone‐secondtimer.
txholdcount SpecifiesthemaximumnumberofBPDUstobetransmittedbefore
transmissionsaresubjecttoaone‐secondtimer.Validvaluesare1‐10.
Defaultvalueis 6.