Specifications

Configuring LACP show port lacp
4-66 Port Configuration
show port lacp
Usethiscommandtodisplaylinkaggregationinformationforoneormoreunderlyingphysical
ports.
Syntax
show port lacp port port-string {[status {detail | summary}] | [counters]} [sort
{port | lag}]
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Only.
Examples
ThisexampleshowshowtodisplaydetailedLACPstatusinformationforportfe.1.12:
Matrix(rw)-> show port lacp port fe.1.12 status detail
Port Instance: fe.1.12
ActorPort: 1411 PartnerAdminPort: 1411
ActorSystemPriority: 32768 PartnerOperPort: 1411
ActorPortPriority: 32768 PartnerAdminSystemPriority: 32768
ActorAdminKey: 32768 PartnerOperSystemPriority: 32768
ActorOperKey: 32768 PartnerAdminPortPriority: 32768
ActorAdminState: -----GlA PartnerOperPortPriority: 32768
ActorOperState: -F----lA PartnerAdminKey: 1411
ActorSystemID: 00-e0-63-9d-b5-87 PartnerOperKey: 1411
SelectedAggID: none PartnerAdminState: --DCSGlp
AttachedAggID: none PartnerOperState: --DC-Glp
MuxState: Detached PartnerAdminSystemID: 00-00-00-00-00-00
DebugRxState: port Disabled PartnerOperSystemID: 00-00-00-00-00-00
ThisexampleshowshowtodisplaysummarizedLACPstatusinformationforportfe.1.12:
portport‐string DisplaysLACPinformationforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
statusdetail|
summary
DisplaysLACPstatusin
detailedorsummaryinformation.
counters DisplaysLACPcounterinformation.
sortport|lag (Optional)Whensummaryisspecified,sortsdisplaybyport
designationorLAGID.
Note: State definitions, such as ActorAdminState and Partner AdminState, are indicated with letter
abbreviations. If the show port lacp command displays one or more of the following letters, it
means the state is true for the associated actor or partner ports:
E = Expired; F = Defaulted; D = Distributing (tx enabled); C = Collecting (rx enabled);
S = Synchronized (actor and partner agree); G = Aggregation allowed; S/l = Short/Long LACP
timeout; A/p = Active/Passive LACP.
For more information about these states, refer to set port lacp (“set port lacp” on page 4-67) and
the IEEE 802.3 2002 specification.