Specifications

show lacp Configuring LACP
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 4-59
show lacp
UsethiscommandtodisplaytheglobalLACPenablestate,ortodisplayinformationaboutoneor
moreaggregatorports.
Syntax
show lacp [state | port-string]
Parameters
Defaults
•Ifstateisnotspecified,aggregatorinformationwillbedisplayedforspecifiedports.
•Ifport‐stringisnotspecified,linkaggregationinformationforallportswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Usage
EachMatrixSeriesmoduleprovidesvirtuallinkaggregatorports,whicharedesignatedinthe
CLIaslag.0.1throughlag.0..Onceunderlyingphysicalports(i.e.;fe.x.x,ge.x.x)areassociated
withanaggregatorport,theresultingaggregationwillberepresentedasoneLinkAggregation
Group(LAG)withalag.x.xportdesignation.
Example
Thisexampleshowshowtodisplayinformationforaggregatorport48:
Matrix(rw)->show lacp lag.0.484
Aggregator: lag.0.484
clear singleportlag 4-65
show port lacp 4-66
set port lacp 4-67
clear port lacp 4-69
show lacp flowRegeneration 4-70
set lacp flowRegeneration 4-70
clear lacp flowRegeneration 4-71
show lacp outportAlgorithm 4-71
set lacp outportAlgorithm 4-72
clear lacp outportAlgorithm 4-72
For information about... Refer to page...
state (Optional)DisplaystheglobalLACPenablestate.
port‐string (Optional)DisplaysLACPinformation forspecificLAGport(s).Valid
portdesignationsarelag.0.1‐48.