Specifications

show port mirroring Configuring Port Mirroring
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 4-53
Purpose
Toreviewandconfigureportmirroringonthedevice.
Commands
show port mirroring
Usethiscommandtodisplaythesourceandtargetportsformirroring,andwhethermirroringis
currentlyenabledordisabledforthoseports.
Syntax
show port mirroring
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplayportmirroring information.Inthiscase,fe.1.4isconfiguredas
asourceportandfe.1.11isatarget,butmirroringisnotcurrentlyenabledbetweentheports:
Matrix(rw)->show port mirroring
Port Mirroring
==============
Source Port = fe.1.4
Target Port = fe.1.11
Frames Mirrored = Rx and Tx
Port Mirroring status disabled.
Note: Eight destination ports must be reserved for an IDS mirror.
For information about... Refer to page...
show port mirroring 4-53
set port mirroring 4-54
clear port mirroring 4-55