Specifications

show port counters Reviewing Port Status
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 4-15
show port counters
Usethiscommandtodisplayportcounterstatisticsdetailingtrafficthroughthedeviceand
throughallMIB2networkdevices.
Syntax
show port counters [port-string] [switch | mib2]
Parameters
Defaults
•Ifport‐stringisnotspecified,counterstatisticswillbedisplayedforallports.
•Ifmib2orswitcharenotspecified,allcounterstatisticswillbedisplayedforthespecified
port(s).
Mode
Switchcommand,Read‐Only.
Examples
Thisexampleshowshowtodisplayallcounterstatistics,includingMIB2networktrafficand
trafficthroughthedeviceforfe.3.1:
Matrix(rw)->show port counters fe.3.1
Port: fe.3.1 MIB2 Interface: 1 Bridge Port: 2
No counter discontinuity time
-----------------------------------------------------------------
MIB2 Interface Counters
-----------------------
In Octets 0
In Unicast Pkts 0
In Multicast Pkts 0
Duplex Duplex mode (half or full) of the specified port. For details on using the
set port duplex command to change defaults, refer to “Setting Auto-
Negotiation and Advertised Ability” on page 4-30.
Type Physical port and interface type.
Table 4-1 show port status Output Details
Output... What it displays...
port‐string (Optional)Displayscounterstatisticsforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
switch|mib2 (Optional)DisplaysswitchorMIB2statistics.Switchstatisticsdetail
performanceoftheMatrixswitchdevice.MIB2interfacestatistics
detail
performanceofallnetworkdevices.