Specifications

Setting Console Port Properties
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 4-3
fe.1.1,fe.1.3,fe.1.7-10
tg.3.1
Thisexampleshowstheport‐stringsyntaxforspecifyingall1‐GigabitEthernetportsinthe
standalonedevice.
ge.3.*
tg.*.*
Thisexampleshowstheport‐stringsyntaxforspecifyingallports(ofanyinterfacetype)inthe
standalonedevice
*.*.*
Setting Console Port Properties
Purpose
Toreviewandsetparametersforoneormoreofthedevice’sconsoleports,includingbaudrate,
autobauddetection,stopbitsandparity.
Commands
Thecommandsusedtoreviewandconfigureconsoleportsettingsarelistedbelowanddescribed
intheassociatedsectionasshown.
For information about... Refer to page...
show console 4-4
clear console 4-4
show console baud 4-5
set console baud 4-5
clear console baud 4-6
show console flowcontrol 4-6
set console flowcontrol 4-7
clear console flowcontrol 4-7
show console bits 4-8
set console bits 4-8
clear console bits 4-9
show console stopbits 4-9
set console stopbits 4-10
clear console stopbits 4-10
show console parity 4-11
set console parity 4-11
clear console parity 4-12