Specifications

Enterasys Matrix N Standalone (NSA) Series Configuration Guide 4-1
4
Port Configuration
ThischapterdescribesthePortConfigurationsetofcommandsandhowtousethem.
Port Configuration Summary
Console Port(s)
EachMatrixSeriesmoduleorstandalonedeviceincludesaconsoleportthroughwhichlocal
managementofthedevicecanbeaccessedusingaterminalormodem.
Fordetailsonconfiguringconsoleportsettings,referto“SettingConsolePortProperties”on
page 4‐3.
Switch Ports
TheMatrixSeriesmodulesandstandalonedeviceshavefixedfrontpanelswitchportsand,
dependingonthemodel,optionalexpansionmoduleslots.Thenumberingschemeusedto
identifytheswitchportsonthefrontpanelandtheexpansionmodule(s)installedisinterface‐type
dependent
Important Notice
CLI examples in this guide illustrate a generic Matrix command prompt . Depending on which Matrix Series
device you are using, your default command prompt and output may be different than the examples shown.
For information about... Refer to page...
Port Configuration Summary 4-1
Setting Console Port Properties 4-3
Reviewing Port Status 4-13
Disabling / Enabling and Naming Ports 4-20
Setting Speed and Duplex Mode 4-24
Enabling / Disabling Jumbo Frame Support 4-27
Setting Auto-Negotiation and Advertised Ability 4-30
Setting Flow Control 4-37
Configuring Link Traps and Link Flap Detection 4-39
Configuring Broadcast Suppression 4-49
Configuring Port Mirroring 4-52
Configuring LACP 4-56