Specifications

Link Layer Discovery Protocol and LLDP-MED set lldp port status
3-28 Discovery Protocols Configuration
Mode
Switchcommand,Read‐Write.
Usage
WhenanLLDP‐MEDendpointdevicehasconnectedtoaport,thenetworkconnectivitydevice
startssendingLLDP‐MEDTLVsatafaststartrateonthatport.Usethiscommandtosetthe
numberofsuccessiveLLDPDUs(withLLDP‐MEDTLVs)tobesentforonecompletefaststart
interval.
Example
ThisexamplesetsthenumberoffaststartLLDPDUstobesentto4.
Matrix(rw)->set lldp med-fast-repeat 4
set lldp port status
UsethiscommandtoenableordisabletransmittingandprocessingreceivedLLDPDUsonaport
orrangeofports.
Syntax
set lldp port status {tx-enable | rx-enable | both | disable} port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleenablesbothtransmittingLLDPDUsandreceivingandprocessingLLDPDUsfrom
remotesystemsonportsge.1.1throughge.1.6.
Matrix(rw)->set lldp port status both ge.1.1-6
tx‐enable EnablestransmittingLLDPDUsonthespecifiedports.
rx‐enable EnablesreceivingandprocessingLLDPDUsfromremotesystemson
thespecifiedports.
both EnablesbothtransmittingandprocessingreceivedLLDPDUsonthe
specifiedports.
disable DisablesbothtransmittingandprocessingreceivedLLDPDUsonthe
specifiedports.
port‐string Specifiestheportorrangeof
portstobeaffected.