Specifications

Link Layer Discovery Protocol and LLDP-MED set lldp tx-interval
3-26 Discovery Protocols Configuration
set lldp tx-interval
Usethiscommandtosetthetime,inseconds,betweensuccessiveLLDPframetransmissions
initiatedbychangesintheLLDPlocalsysteminformation.
Syntax
set lldp tx-interval frequency
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexamplesetsthetransmitintervalto20seconds.
Matrix(rw)->set lldp tx-interval 20
set lldp hold-multiplier
Usethiscommandtosetthetime‐to‐livevalueusedinLLDPframessentbythisdevice.
Syntax
set lldp hold-multiplier multiplier-val
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Thetime‐to‐liveforLLDPDUdataiscalculatedbymultiplyingthetransmitintervalbythehold
multipliervalue.
frequency SpecifiesthenumberofsecondsbetweentransmissionsofLLDP
frames.Valuecanrangefrom5to32,768seconds.Thedefaultis30
seconds.
multiplier-val
Specifiesthemultipliertoapplytothetransmitintervaltodetermine
thetime‐to‐livevalue.Valuecanrangefrom2to10.Defaultvalueis4.