Specifications

Pausing, Clearing and Closing the CLI wait
2-80 Startup and General Configuration
Pausing, Clearing and Closing the CLI
Purpose
TopauseorcleartheCLIscreenortocloseyourCLIsession.
Commands
Thecommandsusedtopause,clearandclosetheCLIsessionarelistedbelowanddescribedinthe
associatedsectionsasshown.
wait
UsethiscommandtopausetheCLIforaspecifiednumberofsecondsbeforeexecutingthenext
command.
Syntax
wait seconds
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtopausetheCLIfor10seconds:
Matrix(rw)->wait 10
cls (clear screen)
UsethiscommandtoclearthescreenforthecurrentCLIsession.
Syntax
cls
For information about... Refer to page...
wait 2-80
cls (clear screen) 2-80
exit | quit 2-81
seconds SetsthenumberofsecondsfortheCLItopausebeforeexecutingthe
nextcommand