Specifications

set telnet Starting and Configuring Telnet
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 2-65
set telnet
UsethiscommandtoenableordisableTelnetonthedevice.
Syntax
set telnet {enable | disable}{inbound | outbound | all}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtodisableinboundandoutboundTelnetservices:
Matrix(rw)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
telnet
UsethiscommandtostartaTelnetconnectiontoaremotehost.TheMatrixSeriesdeviceallowsa
totaloffourinboundand/oroutboundTelnetsessiontorunsimultaneously.
Syntax
telnet host [port]
Parameters
Defaults
Ifnotspecified,thedefaultportnumber23willbeused.
Mode
Switchcommand,Read‐Write.
enable|disable EnablesordisablesTelnetservices.
inbound|outbound
|all
Specifiesinboundservice(theabilitytoTelnettothisdevice),outbound
service(theabilitytoTelnettootherdevices),orall(bothinboundand
outbound).
host SpecifiesthenameorIPaddressoftheremotehost.
port (Optional)Specifiestheserverportnumber.