Specifications

clear license Reviewing and Selecting a Boot Firmware Image
Enterasys Matrix N Standalone (NSA) Series Configuration Guide 2-61
Testing SDRAM.... PASSED.
Loading Boot Image: 01.00.02... DONE.
Uncompressing Boot Image... DONE.
Press any key to enter System Image Loader menu
2. Beforethebootupcompletes,pressanykey.Thefollowingbootmenuoptionsscreen
displays.
Options available
1 - Start operational code
2 - Change baud rate
3 - Retrieve event log using XMODEM (64KB).
4 - Load new operational code using XMODEM
5 - Display operational code vital product data
6 - Run Flash Diagnostics
7 - Update Boot Code
8 - Delete operational code
9 - Reset the system
10 - Restore Configuration to factory defaults (delete config files)
3. Type2.Thefollowingbaudrateselectionscreendisplays:
1 - 1200
2 - 2400
3 - 4800
4 - 9600
5 - 19200
6 - 38400
7 - 57600
8 - 115200
0 - no change
4. Type8tosetthedevicebaudrateto115200.Thefollowingmessagedisplays:
Setting baud rate to 115200, you must change your terminal baud rate.
5. Settheterminalbaudrate to115200andpressENTER.
6. TypedownloadtostarttheZMODEMreceiveprocess.
7. SendtheimagefileusingtheZMODEMprotocolfromyourterminalapplication.(This
procedurewillvarydependingonyourapplication.)WhentheZMODEMdownloadis
finished,thefollowingmessagedisplays:
[System Image Loader]: download
Preparing to receive file...
Writing file...
Download successful.
[System Image Loader]:
8. Setthedevicebaudratebackto9600.