Installation guide

Memory Replacement Procedures

B-6 Mode Switch Settings and Installing Options

Installing the DRAM SIMM

ToinstallaDRAMSIMM,refertoFigure B‐5andproceedasfollows:

1. InserttheDRAMSIMMdownbetweentheconnectorfingers.

2. PivottheDRAMSIMMdownwardsothetabsontheconnectorarmsalignwiththe

twoDRAMSIMMalignmentnotches.Withthetwoconnectorarmsspreadoutward,

pushtheDRAM

SIMMdownbetweentheconnectorarms.Thenreleasethetwo

connectorarmstolocktheDRAMSIMMintoplace.

3. ReinstalltheEthernetinterfacemodule.Proceedto“Installingthe7G‐6MGBIC/

7G‐6MGBIC‐A”onpage B‐9forinstruct ions .

Figure B-5 Installing the DRAM SIMM

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive

electronic equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones

de seguridad para evitar descargas de electricidad estática.

1 DRAM SIMM 3 Connector arms

2 Connector fingers 4 SIMM alignment notches (2)