Installation guide

Using LANVIEW Diagnostic LEDs
4-2 Troubleshooting
Viewing the Receive and Transmit Activity
Youcanviewthe7G4280‐19receiveandtransmitportactivityontheRXandTXLEDs.
However,onlyonegroupofsixportsmaybeviewedatatime.
Toviewthereceiveandtransmitactivityonagroupof7G4280‐19segments, pressthe
GROUPSELECTbutton(seeFigure 4‐
1)forlessthanonesecondtosteptothegroupof
interest(Groups1through3).EachtimetheGROUPSELECTbuttonispressedforless
thanonesecond,theGROUPLEDlightsupinsequence,indicatingwhichgroupis
selected.Thereceiveandtransmitactivityforthatgroup
ofsegmentsisthenindicatedby
theRXandTXLEDsforeachport.
Figure 4-1 LANVIEW LEDs
Table 4‐1describestheLEDindicationsandprovidesrecommendedactionsas
appropriate.
1 MGMT LED 2 Group 1, Port 1 LEDs
Note: The terms flashing, blinking, and solid used in Tab l e 4 -1 indicate the following:
• Flashing indicates LED is flashing randomly.
• Blinking indicates LED is flashing at a steady rate (approximately 50% on, 50% off).
• Solid indicates a steady LED light. No pulsing.
• Alternate indicates LED is flashing in a steady rate other than 50% on, 50% off.
1
2
3
G
R
O
U
OFFLINE/
RESET
COM
CPU
MGMT
GROUP
SELECT
GROUP
33
1
2
4
5
6
1
2
7G4280-19
Gb ENET
À
GROUP
GROUP
SELECT
RX TX
Á