Installation guide

Completing the Installation
Matrix DFE-Platinum Series Installation Guide 3-35
Logging in with an Administratively-Configured User Account
Ifthedevice’sdefaultuseraccountsetting shave beenchanged,proceedasfollows:
1. Attheloginprompt,enteryouradministratively‐assignedusernameandpressEnter.
2. AtthePasswordprompt,enteryourpasswordandpressEnter.
ThenoticeofauthorizationandtheMatrixpromptdisplaysasshownbackinFigure 3‐20.
TheDFE moduleisnowreadytobeconfigured.ForinformationaboutsettingtheIP
addressandconfiguringTelnetsettingsforremoteaccesstoDFEmanagement,referto
Chapter3intheMatrixDFE‐PlatinumSeriesConfigurationGuide.TheCLIcommands
enableyoutoinitiallysetupandperformmoreinvolved
managementconfigurations.
TheMatrixDFE‐PlatinumSeriesConfigurationGuideisavailableonlineat:
http://www.enterasys.com/support/manuals
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed
in“GettingHelp”onpage 1‐8.
Note: Users with Read-Write (rw) and Read-Only access can use the set password
command to change their own passwords. Administrators with Super User (su) access
can use the set system login command to create and change user accounts, and the set
password command to change any local account password. For information on the set
password and set system login commands, refer to Chapter 3 in the Matrix DFE-Platinum
Series Configuration Guide
.