Installation guide

Completing the Installation
Matrix DFE-Platinum Series Installation Guide 3-33
First-Time Log-In Using a Console Port Connection
StarttheCommandLineInterface(CLI)fromthemodule’slocalconsoleportasfollows:
1. Connectaterminaltothelocalconsoleportasdescribedin“ConnectingtoCOMPort
forLocalManagement”onpage 3‐26.Thestartupscreen,Figure 3‐20,displays.
2. Attheloginprompt,enteroneofthefollowing
defaultusernames:
– roforRead‐Onlyaccess,
– rwforRead‐Writeaccess,or
– adminforSuperUseraccess.(ThisaccesslevelallowsRead‐Writeaccesstoall
modifiableparameters,includinguseraccounts.)
3. PressEnter.
4. ThePasswordpromptdisplays.LeavethisstringblankandpressEnter.Themodule
informationand
MatrixpromptdisplaysasshowninFigure 3‐20.
TheDFE moduleisnowreadytobeconfigured.ForinformationaboutsettingtheIP
addressandconfiguringTelnetsettingsforremoteaccesstoDFEmanagement,referto
Chapter3intheMatrixDFE‐PlatinumSeriesConfigurationGuide.TheCLIcommands
enableyou
toinitiallysetupandperformmoreinvolvedmanagementconfigurations.
TheMatrixDFE‐PlatinumSeriesConfigurationGuideisavailableonlineat:
http://www.enterasys.com/support/manuals
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed
in“GettingHelp”onpage 1‐8.
Note: This procedure applies only to initial log-in, and to logging in to a device not yet
configured with administratively-supplied user and password settings.
By default, the Matrix DFE Series device is configured with three user login accounts: ro
for Read-Only access; rw for Read-Write access; and admin for super-user access to all
modifiable parameters. The default password is set to blank (press Enter). For information
on changing these default passwords, refer to Chapter 3
in the Matrix DFE-Platinum
Series Configuration Guide.