Installation guide

Connecting to COM Port for Local Management
Matrix DFE-Platinum Series Installation Guide 3-29
Whentheseparametersareset,theLocalManagementpasswordscreenwilldisplay.
RefertotheMatrixDFE‐PlatinumSeriesConfigurationGuideforfurtherinformation.
Figure 3-18 Connecting a VT Series Terminal
Connecting to a Modem
ToconnectamodemtoanEnterasys NetworksDFE moduleCOMport(Figure 3‐19),use
aUTPstraight‐throughcablewithRJ45connectorsandanRJ45‐to‐DB25maleadapter,
andproceedasfollows:
1. ConnecttheRJ45connectoratoneendoftheUTPstraight‐throughcable
totheCOM
portofthemodule.
2. PlugtheRJ45connectorattheotherendoftheUTPstraight‐throughcableintothe
RJ45‐to‐DB25modemadapter.
3. ConnecttheRJ45‐to‐DB25adaptertothecommunicationsportonthemodem.
4. Turnonthemodem.
1 UTP straight-throughcable with RJ45 connectors 3 RJ45-to-DB25 VT adapter
2 RJ45 COM port 4 VT series terminal
1
2
3
G
R
O
U
OFFLINE/
RESET
COM
CPU
MGMT
GROUP
SELECT
GROUP
33
1
2
4
5
6
1
2
7G4280-19
Gb ENET
Á
ÀÂÃ