Installation guide

Installing 7G4280-19 in Matrix E7, N5, or N7 Chassis
3-12 Installation
Example 6 (Figure 3-6, F)
ThemodulearrangementinthisexampleissimilartotheoneshowninFigure 3‐6,E and
describedinExample5.Theonlydifferenceisthatoneofthebridgingmodules
(7H4382‐25,7H4382‐49,7H4383‐49,or7H4385‐49)isinstalledinslot2,enablingall
modulestocommunicate
witheachother.The7H4382‐49isusedinthisexample.
Rule:Inthisexample,thebridgingmoduleservesasboththeFTM1‐to‐FTM2bridgeand
thefive‐to‐sevenslotproxybridge.The6x3xxdoesnotserveasaproxybridgeinthis
configurationbecausethebridgingmoduleis
inaslotwithalowernumber.
Installing 7G4280-19 in Matrix E7, N5, or N7 Chassis
ToinstallanymoduleintotheMatrix E7 chassis,referto“BackplaneConnectionsand
InstallationRules”onpage 3‐8tofamiliarizeyourselfwiththeFTM1andFTM2backplane
connectionsandthemodulehardwareinstallationrules.Thenproceedto“Preparation”
onpage 3‐12tostarttheinstallationprocess.
ToinstallaDFEmoduleintoaMatrix N7
or Matrix N5 chassis,proceeddirectlyto
“Preparation”tostarttheinstallationprocess.
Preparation
1. Removetheblankpanelcoveringtheslotinwhichthemodulewillbeinstalled.All
otherslotsmustremaincoveredtoensureproperairflowforcooling.(Savetheblank
plateintheeventyouneedtoremovethemodule.)
2. Removethemodulefromtheshippingbox.(Savetheboxandpacking
materialsin
theeventthemoduleneedstobereshipped.)
3. Locatetheantistaticwriststrapshippedwiththechassis.Attachtheantistaticwrist
straptoyourwristandplugthecablefromtheantistaticwriststrapintotheESD 
groundingreceptacleattheupperrightcornerofthechassis.
Caution: Failure to observe static safety precautions could cause damage to the
DFE-Platinum module. Follow static safety handling rules and wear the antistatic wrist
strap.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the
board or components can cause damage.
Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de
electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad
para la manipulación del producto y no olvide utilizar la pulsera antiestática.
No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto
cortante entra en contacto con la placa o con los componentes, éstos podrían dañarse.