Installation guide

Installing Optional Mini-GBICs

3-6 Installation

Installation

ToinstallaMini‐GBICwithanMT‐RJconnection,refertoFigure 3‐3;foranLC

connection,Figure 3‐4;orforanRJ45connection,Figure 3‐5,thenproceedasfollows:

1. HoldtheMini‐GBICwithitstopsidefacingupandits7‐pinedgeconnectorfacingthe

port

slot.

2. CarefullyaligntheMini‐GBICwiththeportslot.

3. PushtheMini‐GBICintotheportslotuntiltheMini‐GBIC“clicks”andlocksinto

place.

Figure 3-3 Mini-GBIC with MT-RJ Connector

Note: The following instructions apply whether you are installing a Mini-GBIC in an

Ethernet interface module as shown in the following figures or in the front-panel port slots

1 through 18 of the 7G4280-19.

1 Mini-GBIC (MGBIC-MT01) 4 Port slot

2 Mini-GBIC

, top side 5 Mini-GBIC, protective dust cover

3 7-Pin edge connector (insertion side) 6 Release tab

7G-6MGBIC-A