Installation guide

Unpacking the DFE Module
3-2 Installation
Unpacking the DFE Module
UnpacktheDFEmoduleasfollows:
1. OpentheboxandremovethepackingmaterialprotectingtheDFE module.
2. Verifythecontents ofthecartonaslistedinTable 3‐1.
3. Removethetapesealonthenon‐conductivebagtoremovetheDFE module.
4. PerformavisualinspectionoftheDFE moduleforanysignsof
physicaldamage.
ContactEnterasys Networksifthereareanysignsofdamage.Referto“GettingHelp”
onpage 1‐8fordetails.
Installing Optional Ethernet Interface Module
Atthetimeofthisprinting,the7G‐6MGBICand7G‐6MGBIC‐Aareavailableforthe
7G4280‐19.RefertoyourreleasenotesforthelatestavailableEthernetinterfacemodules.
The7G‐6MGBICand7G‐6MGBIC‐Aeachprovidesix1‐Gigabitportslotsforoptional
Mini‐GBICconnections.
Installing
a7G‐6MGBIC/7G‐6MGBIC‐Ainvolves
•removingthecoverplatefromtheDFEmodule(7G4280‐19),
• installingthe7G‐6MGBIC/7G‐6MGBIC‐A,and
• installingtheMini‐GBICs.
Table 3-1 Contents of 7G4280-19 Module Carton
Item Quantity
7G4280-19 1
Installation Guide 1
Customer Release Notes 1
Note: Install any optional equipment before proceeding to “Backplane Connections and
Installation Rules” on page 3-8 for an explanation of the rules to install different series
modules in a Matrix E7 chassis.
Caution: An antistatic wrist strap is required to perform the following procedures to
minimize ESD damage to the devices involved.
Precaución: Para minimizar los efectos de las descargas de electricidad estática, deberá
utilizar una pulsera antiestática al realizar los siguiente procedimientos.